Rogaloff Militaria's 4 Space Medal Court Mounting Backing Plate is the perfect solution for both hobbyists and professionals
looking to Court Mount Military Medals.

Manufactured in-house, and right here in Australia, our Court Mounting Backing Plates are primarily made from 2mm acrylic
with pre-tapped securing holes, precision cut by laser to ensure consistency with every unit. A metal backing pin is secured
in a purpose-made recess within the acrylic to provide a flush finish on the reverse of the plate. The backing pins can then be
affixed to the application surface with high quality durable mushroom clip fasteners. 

As not all medals are created equal, depending on the medal(s) required to be mounted, the positioning of the pre-tapped
securing holes to affix the medals to the backing will vary - please check your requirement carefully against the reference
guide below, or contact us direct if you would like to discuss a custom solution.


NOTE: There are strict requirements with respect to Mounting Medals as outlined in the respective Defence Handbooks - 
Rogaloff Militaria strongly recommends the consultation of these handbooks or a professional Medal Mounter before 
attempting any DIY mounting.

ANY MEDALS SHOWN IN IMAGES ARE FOR REFERENCE PURPOSES ONLY AND ARE SOLD SEPRATELY.

Rogaloff Militaria's Court Mounting Backing Plates are an in-house design, and protected by both 
Australian Registered Design (#202017168) and Copyright.
 

Four Space Medal Court Mounting Plate - Reference Guide

 

Version 1 - 128mm x 75mm (Specify order in checkout)
Recommended for Medals with ribbon width of 32mm
I will advise the order of wear

 
Version 2 - 128mm x 75mm (WW2 - One Star / Three Campaign / Service Medals)
Recommended For WWII Medals with a ribbon width of 32mm
Purpose made item

 
Version 3 - 128mm x 75mm (WW2 - Two Stars / Two Campaign / Service Medals)
Recommended For WWII Medals with a ribbon width of 32mm
Purpose made item

 
Version 4 - 128mm x 75mm (WW2 - Three Stars / One Campaign / Service Medals)
Recommended for Medals with ribbon width of 32mm
Purpose made item

 
Version 5 - 128mm x 75mm - (DIY - With Pin, no securing holes)
Recommended For Medals with  ribbon width of 32mm
** This option will require the buyer to drill thier own securing holes

 
Version 6 - 128mm x 75mm - DIY, Acrylic only (no holes or pins)
Recommended For all medals with ribbon width of 32mm
** This option will require the buyer to drill thier own securing holes, and affix thier own mounting pin / brooch

 
Version 7 - ~ 140mm x 75mm - (With Pin, no securing holes)
Recommended For all Medals with ribbon width up to140mm
** This option will require the buyer to drill thier own securing holes

 
Version 8 - ~ 140mm x 75mm - Custom Cut - Acrylic only (no holes or pins)
Recommended For all Medals with ribbon width up to 140mm
** This option will require the buyer to drill thier own securing holes, and affix thier own mounting pin / brooch

 


 

(CMBP-FS-4)

SKU CMBP-FS-4
Unit Of Measure Each

Be The First To Review This Product!

Help other Rogaloff Trading (AU) Pty Ltd users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category